Jan 19, 2026 Leave a message

6061-T6 vs 6061-T651: Understanding Temper Designations

The T Family of Tempers

The letter T in aluminum temper designations indicates thermal treatment to improve strength and hardness. For 6061, the most common tempers are T6, T651, and the extrusion variant T6511. All start from the same base alloy, and they differ mainly in stress-relief processing and dimensional stability, which significantly influences machining accuracy, flatness, and final product performance.

What Is 6061-T6

6061-T6 undergoes solution heat treatment at about 530 degrees C to dissolve alloying elements, rapid water quenching to lock them in place, and artificial aging at about 175 degrees C to allow fine precipitates to form. The result is a strong, corrosion-resistant aluminum suitable for structural and welded applications.

What Is 6061-T651

6061-T651 follows the same route with one critical addition: after quenching and before artificial aging, the material is mechanically stretched, typically 1.5 to 3 percent permanent elongation for plate, reducing internal residual stresses caused by quenching. The 51 designation indicates this stress-relief operation. For extrusions the equivalent is T6511, where stress relief is achieved by stretching or compression depending on the product form.

Direct Comparison

Both tempers have a tensile strength of at least 290 MPa, yield strength of at least 241 MPa, hardness of about 95 HB, and excellent corrosion resistance and weldability. T651 has significantly lower internal stress, excellent dimensional stability, and better machinability, at a slightly higher cost, while T6 has higher internal stress and is more prone to warping during machining but is cheaper and more widely available in extrusions and tubes.

Applications

6061-T6 is used for bicycle frames, marine components, automotive parts, and structural tubing. 6061-T651 is preferred for mold bases, CNC-machined plates, aerospace components, jigs and fixture plates, and semiconductor and precision tooling, and is most often supplied as rolled plate.

Selection Guidance

Choose T651 when tight tolerances, precision machining, or large-plate flatness are required, and T6 for cost-sensitive parts, welded assemblies, and extrusions or round tubes where T6 is more readily available.

Frequently Asked Questions

Q: What does the 51 in T651 mean?

A: Stress relief by stretching after quenching.

Q: Are T6 and T651 the same strength?

A: Yes, mechanical strength values are essentially identical.

Q: Which temper warps less during machining?

A: T651, with reduced residual stress.

Q: What is T6511?

A: The stress-relieved temper for extruded products.

Q: Which is cheaper?

A: T6, without the stretching operation.

Q: What applications prefer T651?

A: Mold bases, CNC plates, aerospace, and precision tooling.

Contact us for 6061-T6 and 6061-T651 plates, bars, and tubes with certified properties and cutting services.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry