Mar 08, 2023 Leave a message

Aluminum sheet surface drawing treatment process

The wire drawing process is done after stamping. The wire drawing can be made into several types such as straight grain, random grain, thread, corrugation and spiral grain according to the decoration needs.

Straight wire drawing refers to the processing of straight lines on the surface of the aluminum plate by mechanical friction. It has the double function of removing scratches on the surface of the aluminum plate and decorating the surface of the aluminum plate. There are two types of straight wire drawing: continuous wire and intermittent wire. The continuous silk pattern can be obtained by continuous horizontal and linear rubbing on the surface of the aluminum plate with a scouring pad or a stainless steel brush (such as manual grinding under the condition of an existing device or using a planer to clamp a wire brush on the aluminum plate). By changing the wire diameter of the stainless steel brush, textures of different thicknesses can be obtained. Intermittent silk patterns are generally processed on a brushing machine or a rubbing machine. Production principle: Two sets of differential wheels rotating in the same direction are used. The upper set is a fast-rotating grinding roller, and the lower set is a slow-rotating rubber roller. The aluminum or aluminum alloy plate passes through the two sets of rollers and is brushed out. Delicate intermittent straight lines.

Random wire drawing is a kind of irregular, non-obvious matte silk pattern obtained by moving and rubbing the aluminum plate back and forth, left and right, under the high-speed running copper wire brush. This kind of processing has higher requirements on the surface of aluminum or aluminum alloy plate.

Corrugation is generally produced on a brushing machine or a rubbing machine. Utilize the axial movement of the upper group of grinding rollers to brush on the surface of aluminum or aluminum alloy plates to obtain wavy lines.

Rotary pattern, also known as optical rotation, is a kind of silk pattern obtained by rotating and polishing the surface of aluminum or aluminum alloy plate by using cylindrical felt or grinding stone nylon wheel on the drilling machine, mixing polishing ointment with kerosene. It is mostly used for decorative processing of round signs and small decorative dials.

The thread is to use a small motor with a round felt on the shaft, fix it on the table, and make an angle of about 60 degrees with the edge of the table, and make a carriage with a fixed aluminum plate to press the tea, on the carriage Apply a straight-edge mylar to limit thread race. Using the rotation of the felt and the linear movement of the carriage, the thread lines with the same width are rubbed on the surface of the aluminum plate.

Sand blasting treatment is to obtain film light decoration or fine reflective surface to meet special design requirements such as soft luster. Even and moderate sandblasting can basically overcome the common defects on the surface of aluminum.

For appearance parts, whether it is brushed or sand blasted, surface oxidation treatment is usually required. As for which processing technology to choose, it should be a question related to modeling. There are still differences in the surface texture that can be obtained by the two processes.

In addition, there is a process close to sand blasting, but it is carried out by a chemical corrosion method, commonly known as chemical rotten sand treatment or chemical sand surface corrosion, which is especially suitable for surface treatment of aluminum materials. The uniformity of the sand surface is much better than that of spraying sand treatment. Chemical sand surface corrosion is divided into acid corrosion and alkaline corrosion. Different surface colors and sand grains can be obtained by different corrosive solvents and sanding agents.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry