A short-process production process for ultra-thin aluminum foil, which is characterized in that it is carried out according to the following process steps:

The first step, smelting: Use a large-capacity regenerative smelting furnace to convert raw aluminum into molten aluminum, which enters the casting and rolling mill through a launder. During the flow of the molten aluminum, the refiner Al-Ti-B is added online to form a continuous and uniform Refinement effect; the graphite rotor degasses and removes slag online at 730-735°C, forming a continuous and uniform removal effect;
The second step, rough rolling: The molten aluminum melted in the first step is introduced into the casting and rolling mill to cast and roll into a billet; during this process, the inlet temperature of the cooling water in the roller body cavity is controlled at 20-23°C, and the outlet water temperature is controlled at 20-23°C. 28-32℃, the static pressure of the aluminum melt between the roll gaps is controlled at 0.004-0.005Mpa, ensuring that the crystallization direction {100} area ratio of the material is >95%, the grain size is ≤5μm, and a slab of 6.5-7.5mm is rolled. ;

The third step, intermediate rolling: Roll the above-mentioned slab again with the cold rolling unit. When the thickness reaches 4.5mm, send it to the annealing furnace, heat it to 360°C, keep it warm for 2 hours, and then continue to heat it to 580°C. , keep it warm for 18 hours, perform homogenization annealing to make the grain size uniform and directionally consistent; then continue to cold roll it in the cold rolling mill to 0.60mm, then send it to the annealing furnace again, heat it to 460°C, and keep it warm for 5 hours Afterwards, the temperature is lowered to 400°C, kept for 7 hours, and intermediate annealing is performed; then continued rolling to a thickness of 0.3mm is used as aluminum foil wool;
Step 4: Foil rolling: Use a four-roller irreversible foil rolling mill to roll the above 0.3mm aluminum foil wool into finished aluminum foil. The production process of the ultra-thin aluminum foil is short, the operating cost is low, and the production investment scale is small. The quality of the ultra-thin aluminum foil produced can reach the most advanced international level. Compared with the hot-rolling production process, the investment cost in producing blanks is reduced. Two-thirds, operating costs are reduced by more than half.





